Bulk Vehicle Blowers

Design with 3-lobe rotors

Cylinder with cast-in pre-inlet channels at discharge side to minimize the sound by pulsation reduction. Therefore only vertical installation position is possible. Speed range between 1450 up to 4800 1/min.

Oil splash lubrication with oil sight glasses on both sides.

Shaft sealings

Conveying chamber by the carbon ring labyrinth seal proven over decades in connection with the neutral chambers open to the atmosphere. Driving shaft with radial seal ring. 

Direction of flow

Vertical, from top to bottom

Design with two-lobe rotors

• The conveying chamber is completely separated from the oil sumps by a space open to atmosphere.
• The machine can be positioned upright, suspended from the top, and suspended from the left or right.
• They are also available with an integrated gearbox with a speed set-up ratio of i=2,1.
• The operating speed range is 1350 to 3200 1/min.
• The drive side is grease lubricated, while the gear side is splash oil lubricated.
• Gear driven models feature splash oil lubrication on both sides. Oil level check by means of dipstick.

Shaft sealings

The conveying chamber is sealed by means of four piston rings in combination with oil slingers adjacent to the vent space.

The drive shaft is sealed by a seal ring. Gear driven models are sealed by a radial seal ring.

Direction of flow

Both directions possible in horizontal or vertcial flow.

Drive

Via direct coupling or narrow v-belt drive.

Special materials

None available. 

DEVELOPED FOR CONVEYING OF AIR.

Aerzen bulk vehicle blowers have been specifically designed to meet the operating requirements of bulk and silo vehicles in the generation of pressure or vacuum needed for the pneumatic loading and unloading of these specialized transport vehicles.